Airport Jetbridge Prop Pack
This is a prop pack containing various parts to create custom jet bridges for an airport. All props share a common 512×512 texture with a 64×64 LOD texture. The Tri count on each prop varies, however, a configuration that uses all assets will probably be around 600 Tris, and will have around a 200 Tri LOD.
Several of the props included in the pack have several different angles associated with them to accomodate different jetbridge heights (and therefore inclinations). The angles are saved in 5 degree increments from 0 degrees to 15 degrees (i.e. 0, 5, 10, and 15 degree variants). Any height can be achieved by using a good angle choice and sliding the parts of the jetbridge into each other. It should be noted that the move it mod, prop snapping mod, and prop anarchy mod are essential to use these props.
The following props are included:
– Jetbridge hood (the part that covers the entry way to the aircraft)
– Jetbridge cab (the part where the control console is)
– Jetbridge root tall (2 story height pivot point)
– Jetbridge root short (ground level pivot point)
– Terminal root (to be cliped into the terminal wall)
– Terminal bridge (the part with windows that allows the root to be placed further away from the terminal)
– Jetbridge start section (part closest to the root pivot) [angles 0, 5, 10, and 15]– Jetbridge middle section [angles 0, 5, 10, and 15]– Jetbridge end section (part closest to the cab) [angles 0, 5, 10, and 15]– Jetbridge wheels (used for positioning the jetbridge)
– ACU (a device mounted on the jetbridge that supplies air conditioning and power the the aircraft) [angles 0, 5, 10, and 15]– ACU Hose (black and yellow striped hoses that connect between the aircraft and the ACU)
I didn not include stairs in the pack since there would be too many angle combinations to reasonably do, and they would be fairly high poly due to the railings.
Loading...
